.

Manufacturers

Jabsco Run-Dry Macerator pump 12V

  • Model: 18590-2092

$719.00NZD

Add to Cart:

Jabsco Macerator Pumps

The Jabsco macerator pump unit is the ideal solution for emptying marine holding tanks when not in a discharge restricted area. Self priming to 5ft these pumps will empty a typical 30 gallon (115litre) holding tank in less than 3 minutes. It is recommended that holding tanks be flushed with several gallons of water after each pump out. This will reduce the possibility of a continued build up of sediment in the tank which could cause a potential blockage.

The 18590 Series are also the ideal solution for the emptying of fish box and livewell receptacles. Very often the livewell tank will be above the waterline of the boat, when this is the case gravity can be used to empty the livewell tank. If not installed in this format then it is beneficial to use the Jabsco macerator pump for evacuation due to its self-priming capabilities and also it's grinding properties.

Features:
Impeller: Jabsco Nitrile compoundNEW
Macerator: Stainless Steel Cutter reduces particle size to 1/8" (3mm) maximum. New 4blade design.
Seal: Lip Type

Specifications:
Pump - Self-Priming Flexible Impeller with Stainless Steel Wearplate
Port(s) - Inlet - 1-1/2" (38mm) Hose Barb and 1-1/2" N.P.T. (Male) Outlet - 1" (19mm) Hose Barb;
Motor - Permanent Magnet Type, Fully Enclosed, with Stainless Steel Shaft Includes Run-Dry Protection Device that shuts-off pump. Powder coated housing with sealed end-bells and bearings. Complies with USCG Regulation 183.410 and ISO 8846 MARINE for Ignition Protection.
Weight - 5 lb 2.3 kg
Voltage - 12 EMC
Amp Draw - 16 A
Fuse Rating - 20 A



This product was added to our catalog on Wednesday 03 March, 2010.

Opening Hours

Mon-Fri: 9:00am-5:30pm
Sat: 9am-4pm
Sun: Closed

We accept credit cards

mastercard and visa
All transactions are processed in NZD and other currencies are indicative only
Copyright © 2021 Discount Marine. Powered by Zen Cart