82 Cable St (Cnr Cable & Tory) Wellington, NZ
Ph: 64-4-385 1490  Fax: 64-4-385 8158
NEW ZEALAND
Opening Hours:
Mon to Fri: 8.30am-5.30pm, Sat 9am-4pm
Sun Closed
email us

Railblaza RIBport

$31.60NZD

Add useful StarPort attachments to your inflatable without having holes cut into the tubing.

Completely compatible with all StarPort accessories

Available in either - White, Grey or Black Please select colour from the list below

What You Get:

  • One RIBPort (150 x 114 x 21 mm)

    Installation
    CAUTION: While the StarPort RIBPORT is straightforward to install, WE STRONGLY ADVISE YOU TO USE A PROFESSIONAL RIB REPAIRER.

  • Remove the StarPort and screws from the base, to avoid potential damage during installation.
  • Clean the surface of both the RIB location and the base thoroughly with Methylethyl Ketone (MEK). The base should align lengthways along the side of the inflatable.
  • Using a mix of Bostick 999HR (or 999HV) and DESMODOUR RFE mixed @ 5%, apply to both the RIB surface and the base. Allow to contact-dry.
  • To mould the base to the curvature of your inflatable's surface, heat the base to about 80°C for NO MORE THAN 3 MINUTES in a dry oven.
  • Carefully align and apply the RIBPORT to the RIB surface, ensuring no air bubbles or dirt becomes trapped in the join, weakening the bond.

    INSTALLATION: StarPort™

  • Allow RIBPORT to cool, then screw the StarPort to the base.
  • NOTE: Use only the screws supplied (12-gauge x 20 mm (0.75 in)). Longer screws may puncture your inflatable.


  • Add to Cart:

    • Model: 03-4004-21W (-51G)(-11B)

    Please Choose:




    This product was added to our catalog on Thursday 21 April, 2011.

    Copyright © 2018 Discount Marine. Powered by Zen Cart