82 Cable St (Cnr Cable & Tory) Wellington, NZ
Ph: 64-4-385 1490  Fax: 64-4-385 8158
NEW ZEALAND
Opening Hours:
Mon to Fri: 8.30am-5.30pm, Sat 9am-4pm
Sun Closed
email us

Cruzpro CC35 8 AMP Three stage PWM Charge Regulator with Automat

$269.00NZD

CC35 Smart Charge Controller/Regulator

The CC35 Automatic Charge Controller is a three step regulator that senses battery voltage and adjusts the regulation to deliver a bulk, absorption and float voltage from your solar panels or dumb battery charger. The CC35 enables you to leave your charging source connected permanently without fear of damaging overcharges or excess electrolyte loss. You are assured you have a fully charged battery whenever you need it.

The CC35 is a true Pulse Width Modulated (PWM) charger that keeps the battery voltage at the prescribed charging voltage irregardless of the load current.

The CC35 bulk charges your battery to 14.5 VDC and keeps it at that absorption voltage for 30 minutes. After 30 minutes the CC35 automatically reduces the charging voltage to 13.6 VDC and maintains that float voltage. If the power demand from the battery exceeds the solar panel supply ability and the battery voltage falls below 12.5 VDC, the CC35 will re-enter the bulk charge mode and recharge the battery to 14.5 VDC before dropping back into float.

A built in Low Voltage Disconnect (LVD) circuit automatically removes the load from your battery if battery voltage falls below 12.5 VDC for more than 1 second. This keeps the battery from going into a deep state of discharge if the charging source is unable to keep up with demand. The built-in time delay prevents the LVD circuit from enabling or disabling on short transients caused by motor start currents, etc.

The CC35 input, output and LVD circuits are short circuit protected

Two front panel LEDs show you what the CC35 is doing at all times: The "Charge" LED reflects the state of the PWM output (brighter for more output, more dim for less output and blinks once per two seconds when no charge is being delivered (battery fully charged).

Specifications
Input Charge Voltage: 7.5 to 30 VDC (Unloaded), 8 amps max.

Battery Voltage/Current Drain: 12 VDC nominal, 0.012 amps typical average current drain.

Operating temperature: 0 to 50 deg Celsius ( 32 to 122 deg Fahrenheit).

Size: 100 x 60 x 30 mm (4 x 2.4 x 1.2 inch)

Function Indicators: Built-in PWM Charge LED and Low Voltage Disconnect (LVD) LED.

Set Voltages: Absorption Voltage - 14.5 VDC for 30 minutes PWM Float Regulation Voltage - 13.6 VDC Absorption Voltage Activation - If battery volts falls below 12.5 VDC Low Voltage Disconnect - 12.5 VDC (Delayed 1 second)

Trip Point Stability, 0 to 50 deg C: Better than +/-0.10 VDC.


Add to Cart:

  • Shipping Weight: 1lbs
  • 5 Units in Stock
  • Manufactured by: Cruzpro


This product was added to our catalog on Tuesday 19 February, 2002.

Copyright © 2017 Discount Marine. Powered by Zen Cart