.

Manufacturers

Altex Epoxy Primer (2-pack) 1.25L

  • Shipping Weight: 5lbs
  • Manufactured by: Altex

$109.00NZD

Add to Cart:

No. 1 Epoxy Primer

Features:

No.1 Epoxy Primer is the basis for High Performance marine systems.

Epoxy Primer No.1 is recommended for use as :

  • Primer on suitably prepared steel, alloy, GRP and wooden substrates
  • Multi-coat primer and self-build system
  • Primer and seal coat for 421 epoxy fairing systems

    No.1 Epoxy Primer may also be used to seal off prepared, aged coatings prior to repainting - refer also to No.4 Epoxy Sealer Undercoat.

    No.1 Epoxy Primer is ideal for use below the water-line as a tie coat between aged epoxies and Altex Yacht & Boat Antifoulings:- No. 5 Ablative, No. 10 Semi-Ablative, Vivid, Hydrocoat.

    Limitations: No. 1 Epoxy Primer is a thin film adhesion primer. It is not designed for thick film application - apply at 50 - 75µm maximum. Further, it is not designed to be sanded - refer to No.2 High Build Sanding Surfacer and No.3 Primer Undercoat.

    Advantages:

  • Excellent adhesion to a wide variety of substrates
  • Formulated for use above and below water - simplifies full hull painting projects
  • Very long mixed pot life
  • Excellent long term re-coatability
  • Lead and chromate free
  • Very rapid dust-free and touch dry response
  • Iso-cyanate free
  • Excellent anti-corrosive properties

    Specific Data:

  • Generic Type: Polyamide Epoxy
  • Colour: Grey
  • Packaging: 1.25 litre and 5 litre, Two component kits
  • Mix Ratio: 4 to 1 by volume
  • Gloss: Flat
  • Flash Point: 27°C
  • Thinner: Spray Altex Thinner #12, Brush/Roller Altex Thinner #22
  • Pot Life: 12hours at 25°C
  • Induction Time: 15 minutes
  • Storage: Store under cool, dry conditions
  • Density: 1.33 kg per mixed litre
  • Volume Solids (Mixed): 45%
  • Theoretical Coverage Rate: 9.0 sq metres per litre at 50 microns dry
  • Recommended Film Thickness Per Coat: 111 microns wet to obtain 50 microns dry
  • Application: Spray, brush or roller
  • Dry Times (50 µm DFT / 25°C / 50% RH):
      Touch Dry 1 Hr,
      Hard Dry 8 Hrs
  • Recoat Times (50 µm DFT / 25°C / 50% RH):
      Minimum - 2 Hr with self, No.3 or No.5 Antifouling
      Maximum Aged - 24 Hrs with Various Antifouling (see above), 3 months with self or No.3

    • Product 1/7

     Previous 
     Return to the Product List 
     Next 

    Customers who bought this product also purchased...

    Ronstan RF5110 Large open
    Ronstan RF5110 Large open
    DLM Standard Anode ZA6
    DLM Standard Anode ZA6

    We accept credit cards

    mastercard and visa
    All transactions are processed in NZD and other currencies are indicative only
    Copyright © 2024 Barton Marine. Powered by Zen Cart